| Ok here is a stock Matrix feed tube and a feed tube I had turned down for the warp/power feed adapter. the finished height should be 1.030" from the bottom to the top for a good ball stack. On later tubes I had the base turned down more to allow the PF adapter to fit down further on the tube. |  |
| This is how you will want to wire a STOCK chipped
Matrix. Some of the after market chips handle the voltage different and cause some run on
issues. I have a few guys working on this and as things change and I get more info Ill
post some updates as to the correct way to wire the different chips. Now as to the wires, I just striped off a bit of the jackets, flattened the wire pulled the chip and carefully pressed the chip back in. If you still have some wire showing use some Glue Stick to insulate the wires from contacting the chip legs next to the wires and causing a short. Red is tapped into the #1 pin on the left side & Black is Tapped into the #1 pin on the right side. |
 |
| Ok Here we have a new chip from the Aardvark Bolt kit.
As you can see we need to move our + pull from the #1 leg to the #2 leg leaving the
ground on the #1 leg on the right side. So far So good on this Matrix Warp Feed gun. Its all golden. |
 |